Concrete Driveway Building in Kingman AZ - a slab planned for desert heat and wind
Old driveway cracked, sunken or holding water? We plan a new pour around the heat, the wind and the ground underneath.
- Licensed and fully insured.
- Free on-site estimates.
- We respond within 1 business day.
What does it take to build a concrete driveway in Kingman?
The short answer: Concrete driveway building in Kingman means our crew prepares the ground, sets forms, and pours and finishes a new slab that drains away from your house. Then we cut joints on time to control where it cracks and let it cure before you drive on it.
Most people call us because the old driveway has cracked, dropped at one corner or started holding water, or because they're building new and need one poured on bare ground. The price mostly follows the size of the driveway, how much old concrete has to come out and be hauled away, how much work the ground needs before we pour, and the finish you choose. The schedule turns on which office covers your address for the permit and on finding a pour day with weather we're comfortable with, and I'll give you your own figure once I've seen the site.
How can you tell your driveway needs replacing?
Cracks that keep widening
A thin crack along a cut joint is what the joint is there for, but cracks that open wider each summer or break a section into pieces usually mean the ground underneath has moved. Waiting lets water get under the slab, and that tends to turn a repair into a full tear-out.
Sunken or tilted sections
When one slab sits lower than the next, or the end by the street has dropped, the soil under it has usually settled or washed out. Every month you drive on it, the broken edges wear down a little more and the trip hazard gets worse.
Water running toward the garage
If rain pools on the driveway or runs back toward the garage door, the slab was poured without enough fall, the gentle slope that carries water away. Left alone, that water works its way under the concrete and softens the ground the driveway depends on.
How we build a concrete driveway
I start by looking at where water runs on your lot, because a driveway should fall away from the house and toward the street. Our crew then breaks out any old concrete, digs down to the subgrade the new slab will sit on and packs it firm so the driveway doesn't settle with loose dirt. We set the forms to the grade we planned and tie in rebar so the steel inside holds the slab together if it cracks. A driveway lives or dies by pour day and by when the joints go in, so we pick the day with you around heat, sun and wind, and we have the joint plan settled before the truck arrives. On the day, we place the concrete, drag a broom finish across the top so the light texture gives tires and shoes some grip, and cut control joints into the surface so the slab has planned lines to crack along. Then it cures, the quiet stretch when it gains strength and you stay off it. If the budget gets tight, I'd rather keep the money in the ground work and go plainer on the finish, because nobody can fix the ground once the concrete is on it.
Since the crew and equipment are already at your house, some people have us pour a concrete patio out back during the same job. If you'd rather the driveway not be plain gray, we also do stamped concrete, and I'd like to talk that through before the pour, since it changes how the crew works on the day.
Replacing an old driveway
This suits a house where the current driveway has cracked through, sunk or drains the wrong way. We break out and haul off the old slab first, because that's when we can see what the ground underneath has been doing and deal with it before we pour.
A new driveway on open ground
This suits people building new on their own land, or adding a driveway where there's only dirt or gravel now. We set the grade and the drainage from scratch, which gives us the most say over how the slab sits and where the water goes.
What happens after you call about a driveway in Kingman?
Thank you for considering us. Here's how a driveway job runs with us, from your first call to the final walk-through, so you know who you'll talk to and when the concrete shows up.
- Step 01
Call us to set a visit
When you call, we set a time for me to come out to your property. It helps to tell us whether there's an old driveway to remove or just bare ground.
- Step 02
I walk the site with you
I look at the ground, where the water runs and how the concrete truck can reach the pour, and I listen to what you have in mind. After the visit you get an estimate with your price for the size, prep and finish we talked about.
- Step 03
Settle permits and pour day
Before we pick a date, we look up which office covers your address, the city or the county. Then we choose the pour day with you, watching the forecast for heat, sun and wind.
- Step 04
Pour, finish and walk through
Our crew preps the ground, sets the forms, pours and finishes the driveway. When it's done, we walk the finished job with you and go over how long to stay off it while it cures.
Concrete driveway building in Kingman: permits and the ground
Before any driveway in the Kingman area gets a pour date, I check which side of the city line your address is on, because Kingman handles its own permits, separate from the county. Outside city limits, the Mohave County Building Division reviews plans and inspects the work, and the county requires a permit for all construction unless the work is specifically exempted, so we don't assume a driveway is. Starting work that needs a permit before you have one brings an investigation fee equal to the permit fee, charged on top of it whether or not the permit is issued later, which is one more reason the paperwork comes before the concrete truck. When your job needs a permit, from the city or the county, we take care of the application.
Problem soils turn up all over Arizona, and two kinds can move a slab: loose, dry soil that was never packed down and can shrink when it gets wet or carries heavy pavement, and clay that swells in a monsoon storm and shrinks again in the dry summer. That's why we dig out and look at the ground before the forms go up, and we watch for the same soils on jobs in Golden Valley and New Kingman-Butler. We work across the cities around Kingman, so if your address isn't on our list, please ask us anyway.
Get your new driveway priced on site
We reply within one business day to set a time for me to come out, look at your driveway and give you a free estimate. There's no obligation to go ahead.
Why Kingman homeowners call Kingman Concrete Company
I give your estimate myself
I come out to see your driveway and give the estimate in person, and I run the work on site while our own crew does the prep, forming, pouring and finishing. The person who priced your job is the one watching it get built, so nothing gets lost between the estimate and pour day.
Trained pouring slabs for a city
I learned concrete on a municipal crew, pouring curbs, walks and slabs, and we've been in business since 2020. That work taught me to plan a pour carefully and check it the same way, because people judge a slab years after it goes in.
Licensed and fully insured, every job
You're welcome to ask about both when I come out for the estimate. It's a fair thing to check before anyone starts work on your property.
Pour hours chosen for the heat
In hot weather, fresh concrete sets faster, which makes it harder to finish and more likely to crack as it shrinks. We plan the crew and the hour so your driveway's surface isn't finished in a hurry.
On a driveway, the parts that matter most are the ground and the joints you won't see once it's done. Send us your details and I'll come out to look at your site.
Concrete driveway questions from Kingman homeowners
How much does a concrete driveway cost in Kingman, AZ?
A concrete driveway in Arizona usually costs about $3,000 to $14,500 per project, and that's the statewide range, not our price. Where yours lands depends on the size, any old concrete to remove, the ground work and the finish. I'll give you your own figure after I've seen the site.
What is the best time of day to pour a concrete driveway in Kingman?
The best time is whenever the weather is favorable, and a national concrete guide suggests pouring at times of day or night that suit the weather and keeping the concrete from losing moisture while it's placed and cured. Wind and sun count as much as heat, because a windy, sunny day calls for more care than a calm, humid one at the same temperature. Wind and low humidity speed drying even on cooler days, so we pick the date with you by watching all three.
Do I need a permit to pour a driveway in Mohave County?
In unincorporated Mohave County, a county permit is required for all construction unless the work is specifically exempted, and inside Kingman the city handles permits separately. As covered above, we look up which office covers your address before setting a pour date and take care of the application when one is needed.
How do I keep a new concrete driveway from cracking badly?
You keep cracks small and far apart with joints placed properly and on time, more reinforcing steel and practical limits on how hot the concrete gets. Concrete can still crack, but those steps govern how big the cracks are and how close together, so they're worth comparing between bids. Our work is satisfaction guaranteed.
Should a contractor add water to concrete on a hot day?
Extra water makes concrete easier to work in the heat, but it can lower its strength and make it shrink more as it dries. It's a fair question to ask any crew before pour day, and I'm happy to answer it for yours.
How long will I be without my driveway when it's replaced?
You're without it from the day the old slab comes out until the new concrete has cured enough to drive on, and I'll give you that timeline for your job at the estimate. The curing wait matters because that's when the slab gains strength, and driving on it too early can damage a new driveway.
Related concrete work around your home
Concrete patio construction
A patio out back gets the same ground prep and pour-day planning as your driveway, so the concrete around your house looks like one planned job.
Stamped concrete services
If the plain gray of a broom finish feels too bare for the front of the house, a stamped pattern and color can give it a finished look.
Call about your new concrete driveway
Have your address and a rough driveway size handy when you call (928) 391-0060 or fill out our estimate form, and tell us whether you're inside Kingman or out in the county, since that decides which office handles the permit.